CHIPSET |
NVIDIA NF3 250 |
SPECIAL FEATURES |
    |
MEMORY |
Maximum 2GB
DDR 333/400
Supports 256-Mb, 512-Mb ,1-Gb DRAM Densities for x8 and x16 non-ECC DDR devices.
|
Dual Channel Guidelines |
Matched DIMM configuration in each channel
--- Same Density (128MB, 256MB, 512MB, 1GB, etc.)
--- Same DRAM technology(128M-bit, 256M-bit, or 512M-bit)
--- Same DRAM bus width (x8 or x16)
--- Both either single-sided or dual-sided
Matched in both Channel A and Channel B memory channels
--- Populate symmetrical memory slots
Optimal platform performance with Dual Channel, DDR400, matched DIMMs
--- Fully loaded configurations can be single or double sided DIMMs
--- Lightly loaded configurations need to be double sided DIMMs
When not using DDR400, best performance obtained with
--- Symmetrical DIMM population and matched double-sided DIMMs
--- Lightly loaded configuration
|
EXPANSION SLOT |
5 x 32 bit PCI slots
1 x AGP (8x)
|
I/O |
1 x CD-In Connector
1 x Parallel , 1 x Serial
2 x IDE Hard Disk Devices (Support Ultra DMA 33/66/100 Bus Master Modes)
1 x RJ-45 LAN Jack
2 x Serial ATA Connectors
8 x USB 2.0 Ports (4 x Rear USB 2.0 , 4 x Front USB 2.0 )
1 x Chassis Open Header
1 x Floppy
1 x Front Audio Header
1 x Front Panel Header
1 x Lin-out/Lin-in/Mic
1 x PS/2 mouse, 1 x PS/2 keyboard
1 x S/PDIF In Header ( Optional )
1 x S/PDIF Out Connector
2 IDE connectors support 2 SATA devices
|
INTEGRATED Audio |
Realtek ALC655 6-Channel AC97 CODEC |
Gigabit LAN |
|
LAN |
Realtek RTL8201BL
Supports 10/100 Mbps transfer rates |
IDE Raid |
Supports 4 IDE disk drives
Supports PIO mode 4,Block mode and Ultra DMA 33/66/100/133 bus master mode |
SATA / Raid |
NVIDIA Raid Technology
--- Raid 0 disk striping for highest system and application performance
--- Raid 1 disk mirroring support for fault tolerance
--- Support for both SATA and ATA-133 disk controller standards
--- Raid 0+1 disk striping and mirroring for highest performance with fault tolerance |
IEEE1394a |
VIA VT6307
--- Supports 2 Ports with Transfer up to 400mbps |
WarpSpeeder |
Hardware Monitor
OverClock
OverVoltage
|
Accessories |
1 x HDD Cable
1 x Serial ATA Cable(Optional)
1 x FDD Cable
1 x S/PDIF Cable(Optional)
1 x Serial ATA Power switch Cable(Optional)
Fully Setup Driver CD
Rear I/O Panel
USB 2.0 Cable (Optional)
User Manual
|
SIZE |
ATX form factor Dimension: 20.5cm x 29.3cm ( W x L ) |
Home
